-
-
Line
@iCshop -
我的帳戶
| 商品簡介 |
原來的LCD1602屏/LCD2004屏，需要7個IO口才能驅動起來，Arduino IIC/I2C/接口轉接板，採用I2C通訊控制,只占用2個IO口，這個模組可以幫你省5個IO口
使用前請確認模組之IC型號，依據型號來調整程式碼中的I2C位址。
如是PCF8574A就修改成0x3F
如是PCF8574就修改成0x27
| 商品規格 |
| 如何查詢I2C位址 |
STEP 1. 將欲查詢的模組連接至Arduino UNO（附圖為腳位參考，實際請比對商品標示接線）
STEP 2. 開啟Arduino IDE並新增檔案
STEP 3. 貼入教學下方的範例文件，並上傳到Arduino UNO，即會開始掃描I2C位址
STEP 4. 開啟序列埠監控視窗，即可取得I2C位址
| / ---------------------------------------------------------------- / | |
| // Arduino I2C Scanner | |
| // Re-writed by Arbi Abdul Jabbaar | |
| // Using Arduino IDE 1.8.7 | |
| // Using GY-87 module for the target | |
| // Tested on 10 September 2019 | |
| // This sketch tests the standard 7-bit addresses | |
| // Devices with higher bit address might not be seen properly. | |
| / ---------------------------------------------------------------- / | |
| #include |
|
| void setup() | |
| { | |
| Wire.begin(); // Wire communication begin | |
| Serial.begin(9600); // The baudrate of Serial monitor is set in 9600 | |
| while (!Serial); // Waiting for Serial Monitor | |
| Serial.println("\nI2C Scanner"); | |
| } | |
| void loop() | |
| { | |
| byte error, address; //variable for error and I2C address | |
| int nDevices; | |
| Serial.println("Scanning..."); | |
| nDevices = 0; | |
| for (address = 1; address < 127; address++ ) | |
| { | |
| // The i2c_scanner uses the return value of | |
| // the Write.endTransmisstion to see if | |
| // a device did acknowledge to the address. | |
| Wire.beginTransmission(address); | |
| error = Wire.endTransmission(); | |
| if (error == 0) | |
| { | |
| Serial.print("I2C device found at address 0x"); | |
| if (address < 16) | |
| Serial.print("0"); | |
| Serial.print(address, HEX); | |
| Serial.println(" !"); | |
| nDevices++; | |
| } | |
| else if (error == 4) | |
| { | |
| Serial.print("Unknown error at address 0x"); | |
| if (address < 16) | |
| Serial.print("0"); | |
| Serial.println(address, HEX); | |
| } | |
| } | |
| if (nDevices == 0) | |
| Serial.println("No I2C devices found\n"); | |
| else | |
| Serial.println("done\n"); | |
| delay(5000); // wait 5 seconds for the next I2C scan | |
| } |
| 出貨清單 |